There are some special components of the screw type sludge dewatering machine. The damage of one component will cause the screw type sludge dewatering machine not to operate, but will not cause damage to the screw type sludge dewatering machine. Therefore, when the stacked screw sludge dehydrator breaks down, we only need to find out which part of the stacked screw sludge dehydrator breaks down, then we can remove it at a fixed point, and let the stacked screw sludge dehydrator re operate with less money. So what are the common parts of stacked screw sludge dehydrator?

1. Motor: power source of stacked screw sludge dehydrator. The dewatering device of stacked screw sludge dewatering machine is a kind of solid-liquid separation equipment which is imported from the United States, digested and absorbed, and developed successfully. It can continuously filter a large amount of sludge. The product is made of high-strength materials, and has the characteristics of large processing capacity, high dewatering efficiency, long service life, etc. the sludge dewatering device is widely used in solid-liquid separation in various industries, and its bearings are widely used Long service life and high quality filter belt ensure the performance and quality of the filter press. If the load of the stacked screw sludge dewatering machine is too large or the power supply is unstable, the motor may be burned and the stacked screw sludge dewatering machine will stop;

2. Motor base: the motor base is likely to be damaged in the process of customers replacing the motor early or carrying the stacked screw sludge dehydrator;

3. The brake opening and closing arm is the brake of the stacked screw sludge dewatering machine. Long term use will lead to the wear of the opening and closing arm (a basic type of component failure);

4. Starting arm: there are two kinds of starting arm: mechanical arm and hydraulic arm;

5. Hu á ng (spring) the damping spring may need to be replaced after the service life of the stacked screw sludge dewatering machine is too long;

6. Bearing: the bearing of stacked screw sludge dewatering machine is the main wear part. Screw stacking machine refers to the residual solid residue after dewatering of wet sludge by means of drainage or filtration. After all kinds of dehydration treatment, the water content is reduced to 65% - 85% and has become wet soil sludge.

7. Other parts.