What do you need to pay attention to when operating the stacked screw sludge dehydrator? Please keep in mind the eight important points of streamlining!

1. Before operation, be sure to be familiar with the manual of the screw stacking machine, and have the most basic understanding of the screw stacking machine.

2. Make sure the screw is flexible and usable.

3. Run for 3-5 minutes, check whether the devices are normal!

4. Check whether the capacity exceeds the upper limit set by the machine.

5. Pay attention to uniform distribution when dewatering sludge machine to prevent machine vibration!

6. During the operation of the sludge machine, do not use the brake device to avoid accidents!

7. The top cover of the machine should not be free of sundries!

8. If there is heating and slipping phenomenon on the clock blue tape of the slave equipment, stop immediately, check the greasy tape, and wipe it with alcohol or gasoline for reuse.

With the development of spiral filtration technology, in order to avoid the problem of clogging, a relatively new type of filter structure appeared in Germany and other European countries in the 1970s, such as grid filter structure, moving and fixed ring filter structure, etc. Among them, the movable and fixed ring structure filter screen is covered with multiple ring pieces on the spiral shaft, which are divided into two kinds: fixed ring piece and movable ring piece. The fixed ring and the movable ring are separated from each other, and there is a certain filtration gap. Through the friction between the movable ring and the fixed ring, the material extrusion is promoted more than hindered, so as to improve the filtration separation effect of the material and avoid the plugging phenomenon of high viscosity materials.