通用banner
your current location : Home >> News >> Industry News

Contact UsContact Us

Jiangsu kangdelong environmental protection Co., L

Address: No. 61, Fenghuang East Road, Hailing District, Taizhou City

Equipment sales: 13852655669 Ms. Sun

Solution: 13852060015 Mr. Huang

After-sales service: 0523-82256069

Mailbox: KDL@KANDEP.COM

website:

en.kandep.com


Screw stacking dehydrator manufacturers share screw stacking machine shutdown process

2021-03-23 01:38:23
a

The appearance of screw folding machine has brought us great benefits, and has been widely used in various places, so what is its shutdown process? Next, I'll give you a brief introduction.

1. Turn off the sludge feeding pump and stop the sludge supply.

2. Turn off the dosing pump and dosing device and stop dosing.

3. Stop the flocculation mixing motor.

4. When the sludge is completely discharged, the filter belt will rotate at high speed to clean the biofilter.

5. Open the drain valve of flocculation tank to drain the sludge.

6. Clean the sludge on flocculation tank and sound card rack with cleaning water.

7. Turn off the main drive system motor, clean the centrifugal water pump and air compressor at one time.

8. Adjust the working pressure of air supply to zero.


叠螺式污泥脱水机厂家

How to solve the problem of screw stacking machine? The following is a brief introduction of its related knowledge by Xiaobian.

1. The screw stacking machine is not running. When the screw stacking machine is not in operation, the electrical circuit should be checked under normal circumstances, only in the initial operation and debugging, when the electrical appliances and circuits are OK. Maybe it's a short circuit, maybe it's aging. If the circuit problem is eliminated, we will check the reducer again to see if there is any problem. This check is mainly to see if there is any heating or abnormal noise.

2. After the initial power supply of the screw stacking machine is started, it can work, but its sludge effect is not ideal, and the work efficiency is relatively low. Generally, the new screw stacking machine should not have such a phenomenon. If the machine has been used for three or four years, it should have more or less such a situation. In fact, after such a situation, as long as you contact the manufacturer of the screw stacking machine, the main shaft of the screw stacking machine should be handed over to the original screw stacking machine Repair work can be done by the manufacturer.

3. Aging of machine parts. Find the aging parts directly and replace them. For other problems or malfunctions, please refer to the product manual attached with the machine.


Recent browse:

Related products

Related news

CONTACT

Address: No. 61, Fenghuang East Road, Hailing District, Taizhou City

Equipment sales: 13852655669 Ms. Sun

Solution: 13852060015 Mr. Huang

After-sales service: 0523-82256069

Mailbox: KDL@KANDEP.COM

  • Mobile station
    Mobile station
  • the public
    the public
CopyRight @ 2020 Jiangsu kangdelong environmental protection Co., L Specializing in Stack screw type sludge dewatering machine price, stacked screw type sludge dewatering machine manufacturer, sludge dewatering complete equipment ,Welcome to inquire!
record number: 苏ICP备19051179号| service support: 新迈科技