We will have all kinds of problems in the process of using any product, including the screw folding machine we use. How to solve the problems when the screw folding machine has problems? The following is a brief introduction of its related knowledge by Xiaobian.

1. The screw stacking machine is not running. When the screw stacking machine is not in operation, the electrical circuit should be checked under normal circumstances, only in the initial operation and debugging, when the electrical appliances and circuits are OK. Maybe it's a short circuit, maybe it's aging. If the circuit problem is eliminated, we will check the reducer again to see if there is any problem. This check is mainly to see if there is any heating or abnormal noise.

2. After the initial power supply of the screw stacking machine is started, it can work, but its sludge effect is not ideal, and the work efficiency is relatively low. Generally, the new screw stacking machine should not have such a phenomenon. If the machine has been used for three or four years, it should have more or less such a situation. In fact, after such a situation, as long as you contact the manufacturer of the screw stacking machine, the main shaft of the screw stacking machine should be handed over to the original screw stacking machine Repair work can be done by the manufacturer.

3. Aging of machine parts. Find the aging parts directly and replace them. For other problems or malfunctions, please refer to the product manual attached with the machine. There are solutions to various problems.