Accidents are inevitable, and many situations can't be predicted in advance. In the work of the dehydrator, if there is a sudden interruption, what should we do? Cut off the power immediately, and then check whether there is a mechanical failure, check which part is broken. The replacement of the replacement, the maintenance of the maintenance. Eliminate any component causes and restart the test.

If it is a common sludge dewatering machine, there is a button on the installation device. When the equipment meets an emergency, it is necessary to press the stop button immediately to stop the operation of the sludge dewatering machine. If you want to restart the sludge dewatering machine after the situation is eliminated, please rotate in the direction of the arrow on the stop button to make the button float, and then restart the sludge dewatering machine Machine.

How should we pay attention to the daily situation?

During the operation of the sludge dewatering machine, the operator must pay attention to its operation at all times. If any abnormality is found, stop the machine immediately to find out the cause, and restart it after troubleshooting. Finally, check whether all the equipment is in normal condition, and add lubricating oil at the designated position regularly!

What do you need to pay attention to when operating the stacked screw sludge dehydrator? Please keep in mind the eight important points of streamlining!

1. Before operation, be sure to be familiar with the manual of the screw stacking machine, and have the most basic understanding of the screw stacking machine.

2. Make sure the screw is flexible and usable.

3. Run for 3-5 minutes, check whether the devices are normal!

4. Check whether the capacity exceeds the upper limit set by the machine.

5. Pay attention to uniform distribution when dewatering sludge machine to prevent machine vibration!

6. During the operation of the sludge machine, do not use the brake device to avoid accidents!

7. The top cover of the machine should not be free of sundries!

8. If there is heating and slipping phenomenon on the clock blue tape of the slave equipment, stop immediately, check the greasy tape, and wipe it with alcohol or gasoline for reuse.